S
S
e
e
r
r
v
v
i
i
c
c
e
e
M
M
a
a
n
n
u
u
a
a
l
l
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
T
T
r
r
o
o
u
u
b
b
l
l
e
e
s
s
h
h
o
o
o
o
t
t
i
i
n
n
g
g
1
1
8
8
3. Check power to console.
4.Replace lower controller.
LED displays not bright,
incomplete or imperfect.
1. LED displays are broken. 1. Replace with new console and calibrate
it.
When press “START”
button to start treadmill,
running belt isn’t running
and window displays
“LOW SPEED” error
message after 8 seconds.
1. Controller experienced unusual shut down; the S_D light will
be always bright. (Controller debugging form
)
2. Motor wires (red, black) aren’t plugged into controller.
3. Computer cables not connected properly.
4. Computer cables are broken or damaged.
5. Motor belt is broken.
6. Controller is broken.
7. Motor is broken.
8. Console is broken.
1. Turn off power and reset the treadmill.
2. Plug wires again.
3. Plug the wire again on controller,
connector and console.
4. Replace with new wires.
5. Replace with new motor belt.
6. Replace with new controller.
7. Replace with new motor.
8. Replace with new console.
When press “START”
button to start treadmill,
running belt is running but
window displays “LOW
SPEED” error message
after 8 seconds.
1. Misalignment between speed sensor and magnet.
2. The 12C508A was broken on the controller.
3. Magnet missing.
4. Magnet de-magnetized.
5. Speed sensor cable is broken. (short)
6. 12 PIN computer cable connected improperly.
1. Adjust the distance to 5mm between
speed sensor and magnet.
2. Replace “12C508A” or controller.
3. Replace a magnet.
4. Use metal material to test the magnet.
5. Replace sensor cable.
6. Plug the cable again on controller,
To Next Page
Loading...