1. Load Tape
Expose 3" of the tape, open the tape compartment (A), and insert so that ‘U’ shape opening in the
tape cartridge points down. Insert the tape into the feed slot and thread forward until visible.
Close the tape compartment to lock in the tape.
2. Advance Tape
By turning the feeder (B) or with several half-squeezes (squeeze until click sound is audible) of
the handle (F), advance the tape 1/4" past front of embosser.
3. Emboss Letters
Turn the wheel (E) until the desired letter aligns with selector. Squeeze the handle (F) firmly and
repeat for each letter. To space between words, half-squeeze handle until click is heard.
DO NOT HOLD WHEEL WHILE EMBOSSING.
4. Cut Tape
Squeeze the cutter (C) and remove excess tape from the end of the embosser.
5. Apply Label
Pull the end of the tab to strip the backing. Apply tape to a clean dry surface.
6. Change Wheel
Push wheel right to left and remove. Snap in the new wheel.
DO NOT SQUEEZE HANDLE WHILE CHANGING WHEEL.
To Previous Page
Loading...
Need help?
General
