Dymo 1570 User Manual

DYMO 1570
Adjusting Space on Label Ends
For more blank spaces before and after messages: Turn the tape feeder (B) .
For less blank spaces: Turn the tape feeder (B) in reverse, emboss the message, turn feeder
forward, and cut.
To center a message: Advance completed label 3 spaces (5 space for 1530 Office Mate I)
Squeeze tape cutter.
Troubleshooting
Label shows letters instead of blank space: Squeeze handle half way until you hear a click,
then release.
Letters too light: Squeeze harder by holding the upper end of the handle.
Tape jam: In the unlikely event the tape does not feed properly, remove the tape wheel, discard
left over tape ends, and replace the wheel.
Preparing Problem Surfaces
Use non-residual solvents (i.e., alcohol, acetone) to clean oily or greasy surfaces. If the surface is
rough or porous, coat it with a sealer (i.e. shellac, lacquer). Once stuck, water will not affect the
label. Do not apply labels to surfaces exceeding 140 F.

Dymo 1570 Specifications

General

Brand	Dymo
Model	1570
Category	Label Maker
Language	English

Summary

Adjusting Space on Label Ends

Add Blank Space

Turn the tape feeder (B) to add blank spaces before and after messages.

Reduce Blank Space

Turn tape feeder (B) in reverse for less blank space.

Center Message

Advance label 3 spaces to center a message.

Troubleshooting

Letters Instead of Blank Space

Squeeze handle halfway until a click, then release.

Letters Too Light

Squeeze harder by holding the upper end of the handle.

Tape Jam

Remove tape wheel, discard tape ends, and replace wheel.

Preparing Problem Surfaces

Operating Instructions

Load Tape

Insert tape cartridge with 'U' shape opening pointing down and thread tape.

Advance Tape

Advance tape 1/4" past embosser using feeder or half-squeezes.

Emboss Letters

Align letter with selector, squeeze handle firmly for each letter.

Cut Tape

Squeeze cutter to remove excess tape from the end.

Apply Label

Strip backing and apply tape to a clean, dry surface.

Change Wheel

Push wheel to remove and snap in the new wheel.