EasyManuals Logo

Dyna-Glo DGL260SNP User Manual

Dyna-Glo DGL260SNP
61 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
17
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The burner will not
light with a match.
No gas ow or an
obstructed gas ow.
1. Match not close enough to
burner ports.
2. Empty tank.
3. Poor connection between
the propane cylinder to the
regulator assembly.
4. Burner inlet blocked.
1. Empty tank.
2. Poor connection between
valve regulator and LP
cylinder coupling.
3. Burner inlet blocked.
1. Position the match closer to burner ports.
2. Replace with a new propane cylinder.
3. Turn off griddle knob. Disconnect and re-
connect the propane cylinder to the regu-
lator assembly.
4. Clean the burner inlet (venturi)
and burner as described by the
Care and Maintenance section
in the manual.
1. Check fuel level and replace
fuel if necessary.
2. Turn off griddle knobs, close the LP
cylinder valve at top of cylinder
and check the connection
between the regulator valve
and cylinder coupling.
Disconnect and reconnect, if
necessary.
3. Clean the burner inlet (venturi)
and burner as described by the
Care and Maintenance section
in the manual.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dyna-Glo DGL260SNP and is the answer not in the manual?

Dyna-Glo DGL260SNP Specifications

General IconGeneral
BrandDyna-Glo
ModelDGL260SNP
CategoryGriddle
LanguageEnglish