What to do if my Dyna SC-12 engine starts hard?
If your Dyna Industrial Equipment engine starts hard, use fresh, clean fuel, avoiding ethanol-type fuels. Inspect and replace the air and fuel filters. For gas models, check the spark plugs. For diesel models, check the glow plugs.
Why does my Dyna SC-12 saw motor stall?
The saw motor on your Dyna Industrial Equipment may stall due to several reasons. The pressure on the saw feed cylinder might be too high; it should be approximately 75 psi. Alternatively, the soft start spring could be set too hard, or the saw chain may be dull. Check the splitter pressure to ensure it is within the correct parameters.
What to do if the saw bar on my Dyna SC-12 Industrial Equipment does not cut all the way through the log?
If the saw bar on your Dyna Industrial Equipment isn't cutting all the way through, it could be due to a worn bar causing the chain to bind. Increase the saw feed pressure to 110 psi and consider replacing both the bar and the chain.
What to do if the splitter on my Dyna SC-12 stalls?
If the splitter on your Dyna Industrial Equipment is stalling, the pressure may be too low. It should be between 250-300 psi.
What to do if the saw motor on my Dyna SC-12 Industrial Equipment is stuck?
If the saw motor on your Dyna Industrial Equipment is stuck, the relief valve on the clamp may be set too low. Set it to around 60 psi. Also, the relief valve may need to be cleaned.
How to fix the saw bar hitting the guard when it returns on my Dyna Industrial Equipment?
To fix the saw bar hitting the guard when it returns on your Dyna Industrial Equipment, the saw bar pivot needs adjustment forward. Check that the soft start plates are even on the top when the saw bar is in the up position. Adjust the saw feed clevis up.
How to adjust the splitter detent on my Dyna SC-12 so it holds until fully retracted?
With the hydraulic oil warmed to operating temperature, adjust the detent adjustment bolt in until it holds on your Dyna Industrial Equipment.
General| Category | Industrial Equipment |
|---|---|
| Model | SC-12 |
| Frequency | 50/60 Hz |
| Manufacturer | Dyna |
| Humidity | 20% to 90% RH (non-condensing) |
To Next Page