EasyManua.ls Logo

Dyna SC-12 - Page 10

Default Icon
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
18
!
WARNING
Before transporting machine follow the transportation procedures
of this manual found in the “Transportation Procedures” section.
Always use the correct size ball or hitch coupler. Always fasten
safety chains onto hitch by crossing them underneath the tongue.
Make sure jack and stabilizer leg is fully retracted and secured.
Double check the hitch lock and insure it is properly latched
before taking o󰀨. Make a round surrounding the machine, double
checking that the deck arms are securely pinned, discharge
conveyor safety chain is properly hooked, conveyor transport
brackets are installed, conveyor belt keeper pin is in place and
there are no loose pieces of wood or tools on the machine. Watch
for any dangling machine parts that might be loose or broken.
Make sure all caps on tanks are tight and properly secured.
Remove keys from ignition to avoid losing them. If equipped with
lights, make sure they are working properly. Check tire pressure
and make sure wheel lugs are tight.
!
DANGER
Operator or any bystander must be a minimum of 30’ from
machine while logs are loading onto deck. Falling or rolling logs
will cause severe injury or possibly death. Personnel loading logs
onto deck must very careful and watchful of hitting or hanging
forks or bucket on machine or deck. Lowering logs onto deck
must be done very slowly and carefully. Always beware that logs
will potentially start rolling or falling against machine causing
machine damage or injury.
!
DANGER
Never climb into the conveyor at any time. Never ride on the
conveyor belt while in motion or in transport. Never remove a
piece of wood from the conveyor while in operation. Never reach
underneath the conveyor while in operation. Never remove any
foreign objects such as sticks, bark, branches, slivers or any
kind of material lodged anywhere on the conveyor while the
machine is in operation. This refers to the at rollers, frame, belt,
or the bearings. Any contact with a moving belt is always very
dangerous and will grab any clothes or body parts, potentially
dragging a person into the machine and consequentially causing
injury or death.
SAFETY IN SET-UP PROCEDURES
!
WARNING
Any person that is intoxicated or mentally impaired by alcohol
or drugs must stay at least 100 ft. away from the machine. Any
unreasonable and senseless behavior is prohibited anywhere
near the general vicinity of the machine. Any person operating the
machine in such condition will result in severe injury or death.
!
WARNING
Improper use of this machine can result in severe injury or death.
Only qualied personnel are allowed to operate this machine.
All potential operators must be trained and familiarized with this
manual before operating this Dyna Firewood Processor.
!
CAUTION
Be cautious of the site selection which you
plan on operating this machine. Absolutely no
slope is necessary for both smooth operation
and safety of the operator. As logs advance
toward saw feed deck and as wood falls into
splitter it is essential that the machine is on a level plane.
IMPORTANT SAFETY INFORMATION IMPORTANT SAFETY INFORMATION
X