7
6
WARRANTY INFORMATION WARRANTY INFORMATION
Certain wear parts are not covered under this warranty. Saw bar,
saw chain, canvas covers, and tires are not covered under any
circumstances. Splitting wedge and discharge conveyor belt
limited to the rst 90 days.
Hydraulic components must be returned with all ports plugged
or capped. Any contamination within the component will void
the warranty. All components must be complete as shipped from
factory.
Warranty is only valid when the machine has been operated under
normal circumstances and was properly maintained according to
manufacturer recommendations. Any damages caused by foreign
material or logs that are larger than rated for this model are not
covered by this warranty.
Owner agrees while requesting any warranty claims or
reimbursements that only replacement parts or repairs of existing
defective parts will be provided.
machine to a Dealer or engine service center. Arrangements must
rst be made with either the manufacturer or the selling dealer. The
manufacturer does not normally reimburse the customer for any
traveling costs that occur in such cases.
All engine (CAT, KUBOTA, KOHLER, or HONDA) warranties are
handled through their manufacturer. (typically 2-3 years) These do
not come under the warranty covered by DYNA Products. Contact
info provided below.
CAT..............................................................................231 734 4433
KUBOTA Engine Power .............................................. 262 560 3214
KOHLER General Power ............................................ 800 508 3246
HONDA Pace Equipment ........................................... 800 686 3128
Proper storage and adequate lubrication is important for this
machine. Engine oil and coolant levels must be checked daily.
Failure to replace wear parts or maintaining proper adjustments
can cause consequential damage. Impairments caused by neglect
on any of these issues are not covered by manufacturer’s warranty.
Fire or heat damage caused by failure to remove canvas engine
cover is not covered by manufacturer’s warranty. This refers
to damages of any kind to the cover, engine, or any part of the
machine.
Transport damages such as road wrecks or any collision of any
sort during transit are not covered by manufacturer’s warranty.
Bolts and nuts should be checked periodically. All shielding
and guarding must be properly installed and functional to keep
warranties valid.
To Next Page
Loading...