DYNACO Dynalogix II - AC;LOOP Timer Setting

Manual & Automatic Close Timers
DYNACO USA, INC, 9 The Leader in Door Safety & Design
Note: If value is set to zero, the timer is deactivated and the activations put on
terminal number 2 is now in manual operation.
4.2 Setting AC/LOOP Timer
1. Press and release AC/LOOP timer button on the Dynalogix II controller.
The display will change to: AC Delay_Timer=##. See figure 4.2-1.
2. Use the Up and Down arrow buttons to change the countdown time to the
desired duration. The Dynalogix II will automatically save any changes that
are made. See Figure 4.2-2.
Figure 4.2-2: Raise/Lower AC/LOOP Timer
JOG
UP/RESET
JOG
DOWN
OPEN CLOSE
MC/PB AC/LOOP
PROGRAM
CLOSE
TIMERS
RUN
TIMERS
MENU
ENTER
Increase
Setting
Decrease
Setting
Note: AC/LOOP timer is also used when the reversing edge is triggered
AC/LOOP
Timer
Figure 4.2-1: AC/LOOP Timer
JOG
UP/RESET
JOG
DOWN
OPEN CLOSE
MC/PB AC/LOOP
PROGRAM
CLOSE
TIMERS
RUN
TIMERS
MENU
ENTER
MESSAGE DISPLAY / COUNTER
AC Delay
Time=##
Note: If value is set to zero door will come down after it reaches the open limit.