EasyManua.ls Logo

Dynacraft 24V UTV - HOW TO USE YOUR VEHICLE; FOOT PEDAL; FORWARD-REVERSE SHIFT LEVER; SOUND BUTTON

Dynacraft 24V UTV
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
20
NOTE:
This product has CHARGING PROTECTION: when charging, all the functions
will be cut off.
Initial charge - At least 18 hours, and never charge the battery longer than 30
hours.
When the vehicle begins to run slowly, recharge the battery.
After each use or once a month at minimum, recharge the batter for at least 12
hours, but never more than 30 hours at most.
WARNING: Use the charger in dry locations only.
HOW TO USE YOUR VEHICLE
Forward/Reverse Shift Lever
Sound Button
Foot Pedal
FOOT PEDAL
To move the car, press the foot pedal down.
To stop, take your foot off the foot pedal.
FORWARD-REVERSE SHIFT LEVER
To move the car forward at high speed, shift the lever to the “2” position.
To move the car forward at low speed, shift the lever to the “1” position.
To move the car backward, shift the lever to the “R” position.
NOTE: Use low speed until you get familiar with your new vehicle.
WARNING: The vehicle does not have brakes. Do not park or ride on any slopes
or steep inclines.
SOUND BUTTON
To activate sound, press the button on the steering wheel.
STOP
To stop the vehicle, you must take your foot off the pedal.
Top LED Lamp Button
Top LED Lamp
Press the red power button (on back of the LED Lamp and right side under the
front roof) to switch On or Off.
NOTE: To save the battery, the LED Lamp will shut off after 3 minutes. To use the LED
Lamp after it shuts off, just press the power button on the LED Lamp again.
NOTE: For your safety, this ride-on toy has been designed with a one second delay start.
When the pedal is pressed, the ride-on toy will start to move one second later.
E

Related product manuals