What to do if Dynaflox Measuring Instruments frequently displays readings?
If your Dynaflox Measuring Instruments frequently displays readings, it might be due to excessive bubbles or impurities in the liquid. To resolve this, try releasing the air or removing the impurities from the liquid.
Why Dynaflox Measuring Instruments shows long-term display?
If your Dynaflox Measuring Instruments shows a long-term display, it could be due to an empty pipe. Ensure the pipe is filled with water. If the pipe is filled with water and the issue persists, it may indicate meter failure.
General| Accuracy | ±1% of reading |
|---|---|
| Technology | Ultrasonic |
| Application | Liquid flow measurement |
| Fluid Types | chemicals |
| Temperature Range | -40°C to +200°C |
| Power Supply | 24V DC or 100-240V AC |
| Output | 4-20 mA, pulse, frequency |
| Pipe Sizes | 1 inch to 48 inches (25 mm to 1200 mm) |
Provides dimensional data and installation guidelines for DN15-25 water meters.
Details the LCD display components and functions for DN15-25 water meters.
Details the LCD display components and functions for DN32-300 water meters.
An introduction to the Modbus-RTU communication protocol used by the water meter.
Defines the structure and components of the Modbus-RTU protocol message frame.
Lists and describes the Modbus registers available for reading data from the water meter.
Provides common fault codes, details, and solutions for troubleshooting the water meter.
Outlines the warranty terms and conditions provided by Dynaflox for the water meters.
To Next Page