Dynaflox ultraD User Manual

ultraD Series Water Meter Manual
8
2 bytes
(register address)
2 bytes
(number of register)
The first two bytes are the first address of the register to be read;
The last two bytes are the number of register to be read (up to 22).
1 byte
the number of bytes in data
area
N bytes
specific register data
When the machine responds, the first byte is the number of bytes in data area (not including itself);
The following bytes in data area are the value of the register to be read; the length is determined by the first byte.

CRC Code: two-byte error detection code. Low byte is in front of high byte.

Terminator: after the transfer of the last character, the pause time of 4 character marks the end of the
message.
5.3 Register List
Baud rate
1200
2400
4800
9600
Parity bit
None
Stop bit
1
Data bit
8
Address
Length
Data Type
Data Content
Unit
Remark
0
2
long
Instantaneous flowrate
L/h
2
2
long
Positive cumulative flow
(integer part)
m3
4
2
long
Positive cumulative flow
(decimal part)
mL
6
2
long
Negative cumulative flow
(integer part)
m3
8
2
long
Negative cumulative flow
(decimal part)
mL
10
2
long
Run time
s
12
2
long
Fault time
s
14
2
long
Battery voltage
mV
16
1
int
Error code
Historical data
0x9000
1
int
Number of historical data
per hour
0x9001
1
int
Number of historical data
per day

Dynaflox ultraD Specifications

General

Brand	Dynaflox
Model	ultraD
Category	Measuring Instruments
Language	English