To Next PageTo Next Page
Need help?Do you have a question about the Dynalco SST2000 Series and is the answer not in the manual?
Overview of the SST-2000A/H series speed switch and transmitter, detailing its applications and basic functionality.
Details the physical dimensions of the SST-2000A/H unit with diagrams showing top and side views.
Lists available SST-2000 series models (A and H) and their respective third-party certifications.
Outlines the primary features of the SST-2000A/H, including signal sources, input frequency, alarm set points, and outputs.
Provides detailed electrical specifications for the SST-2000A/H, covering input, output, power, and performance parameters.
Details relay specifications, logic programming, and optional XP-rated enclosures for the SST-2000 series.
Covers device options like enclosures and pneumatic trip, along with environmental operating conditions and weight.
Guides on how to mount the unit and details internal commons and electrical connection procedures, including warnings.
Explains how to connect signal sources, like a PG-278 Pulser, to the SST-2000A/H terminals.
Details using the SST-2000A/H repeater output for frequency instruments and connecting DPM-105 meters as indicators.
Provides instructions for connecting more than one DPM-105 meter to the SST-2000A/H for speed indication.
Explains how to use the SST-2000A/H's 14 Vdc supply to power zero velocity pickups and digital indicators.
Guides on using the SST-2000A/H to drive an SPV-200 valve, including resistor requirements for 14 Vdc and 28 Vdc.
Describes how to access and understand the programming switch settings located under the top plate of the SST-2000A/H.
Details procedures for setting and modifying the full-scale input frequency range of the SST-2000A/H.
Provides instructions for calibrating the SST-2000A/H, especially after changing the full-scale frequency range.
Explains the procedure for calibrating the 4-20 mA proportional output or other voltage outputs on the SST-2000A/H.
Guides on programming relay set points and logic using DIP switches, including how to reset latched relays.
Details specific configurations for set points 3 & 4 (DPDT trip) and set points 1 & 2 (voltage output).
Covers adjusting signal sensitivity for standard inputs and desensitizing for contact closure inputs on the SST-2000A/H.
Explains response time and provides methods for adjusting individual set points for relays on the SST-2000A/H.
Details methods for adjusting set points while the engine is operating, including considerations for noise.
Provides a method for adjusting set points when high ambient noise makes hearing relay clicks difficult.
Describes how to view and adjust set point values without running the engine using jumpers and a meter.
Details the procedure for adjusting set points using a 0-1 mA meter, including connecting jumpers for specific set points.
General| Brand | Dynalco |
|---|---|
| Model | SST2000 Series |
| Category | Transmitter |
| Language | English |
