Dynalco SST-2400A - User Manual

3211 Fruitland Ave
Los Angeles, CA 90058
SST2000 Series
Universal Speed Switch & Speed Transmitter
Installation and Operation Manual
Rev. C
P/N: 145F-11761
PCO – 00010383
(c) Copyright 2016, Barksdale, Inc.
All Rights Reserved
Published: Oct 20, 2016
中国授权代理商：信德迈科技（北京）有限公司
北京朝阳区望京ＳＯＨＯ－Ｔ１－Ｃ座２１１５室
Ｐｈｏｎｅ：０１０－８４２８ ３９５ Ｅｍａｉｌ： ｓａｌｅｓ＠ｃｎｍｅｃ．ｂｉｚ
网站： ｈｔｔｐ：／／ｗｗｗ．ｃｎｍｅｃ．ｂｉｚ／ｄｙｎａｌｃｏ．ｈｔｍ

Summary

IMPORTANT - PLEASE READ BEFORE PROCEEDING!

Safety Warnings and Support

Critical safety warnings, contact information for support, and trademark notices.

Chapter 2 Installing the SST-2000 A;H

Mounting and Electrical Connections

DC Power Connection Warning

Critical warning about potential DC power connection damage and required isolation measures.

Driving SPV-200 Valve and Powering

SPV-200 Coil Damage Warning

Critical warning about preventing coil damage when driving the SPV-200 valve.

Chapter 4 Calibrating the Speed Switch

Calibrating the SST-2000 A;H

Calibration Timing Warning

Important timing for calibration after switch changes or before set point adjustments.

Calibrating Proportional Outputs

Programming Set Points and Relays

Adjusting Signal Sensitivity

Response Time and Set Point Adjustment

Set Point Adjustment Methods

Engine Operating Warning

Critical warning against adjusting set points while the engine is at critical overspeed.

Verifying Set Point Values

Adjusting Set Point Values

Set Point Adjustment Warning

Warning about potential relay trip if set point is lowered below current operating speed.

Dynalco SST-2400A Specifications

General

Brand	Dynalco
Model	SST-2400A
Category	Transmitter
Language	English