B. The sauna should be unplugged when not in use.
C. To set the temperature, press the temperature buttons to increase or
decrease the temperature to the desired temperature. If the “Heat" light is on, the
temperature setting will increase one degree every time the button is pressed.
If pressed for three seconds, the setting will increase quickly. Decrease the
temperature in the same manner by pressing the button. After the sauna
reaches the desired temperature, the “Heat” light will turn off.
D. Press the button to turn the light ON. If you want to use the Color Light
Therapy System:
A. While the interior light is ON, press and hold down the button
for 2 seconds. You will notice “2n” in the LED display. This indicates you are
in the “light” mode. If you do not press any buttons for approximately 15
seconds, the “2n” will change back to the Timer mode.
B. While the “2n” is displayed, you can now turn the exterior light ON/OFF by
pressing the button in the section of the control panel.
C. You can also turn the interior light ON/OFF by pressing the button in
the section of the control panel.
D. While the interior light is on and the “2n” is still displayed in the LED display,
you can press the button to scroll through the different colors within
the Color Light Therapy System. You will notice that you have two selections
for “white”:
A. The first selection for “white” will allow the colors to go through a
sequence of the different shades of colors.
B. The second selection for “white” will continue to display the white
light.
To return back to the Timer mode, press the button.
Page 13
To Next Page
Loading...