EasyManua.ls Logo

Dynamic DYN-6119-01 - Page 15

Dynamic DYN-6119-01
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
E. You can operate the sauna with the ceiling vent in the open or closed position.
F. After your sauna session is over, you can turn the control panel off by pressing the
ON/OFF button. You can unplug the sauna cord if the sauna will not be used for an
extended period of time.
G. To set the time, press the buttons. Press and buttons to set
the timer from 5 to 60 minutes. If pressed for three seconds, the timer will
increase/decrease quickly. To extend the sauna session, reset the timer again by
pressing the .
H. The Fahrenheit and Centigrade display can be switched by pressing and holding
simultaneously the temperature button & at the same time and then
pressing the and then letting go of all three buttons together.
I. The Bluetooth function is built into the Control Panel. For the Bluetooth function,
you first will need to pair your device with the sauna room. Open your device’s
Settings Menu and then locate and open Bluetooth. You will find BT-AUDIO. Now
you can pair your device. Once pairing is successful, your device will be connected.
You will control the volume and choose the music on your device.
J. The MP3 Jack will allow you to connect your musical device using the AUX wire.
Plug one end of the AUX wire into your musical device and the other end into the
MP3 Jack at the ceiling. Do not leave the AUX wire connected at the ceiling when
not using this function as it may cause static interference at the speakers. You will
control the volume and choose the music on your device. When you disconnect the
MP3 wire, the sound system will automatically return back to the Bluetooth mode.
CAUTION: Exit sauna immediately if you feel dizzy,
sleepy, or any discomfort.