EasyManua.ls Logo

Dynapac LH800 - Operation - Remote Control Driving; Speed and Throttle Control; Joystick Control Functions

Dynapac LH800
30 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 ILH800EN2
Right
Forward
Left
Reverse
Control
The positions of the remote control joystick have the
following functions:
Forward The machine moves forward.
Reverse The machine reverses.
Right The machine rotates to the right.
Left The machine rotates to the left.
0 Vibration and the machine stop if the joystick
is released.
0
1. Give full throttle by setting the speed switch (2) to
“high” (hare).
Make sure that the working area is safe. Wet
and loose ground reduce the machine’s
operating ability, especially on slopes.
Never leave the machine with the engine
running, always switch off the master switch
(14) when leaving the machine. Do not allow
passengers on the machine.
Do not operate the machine at a greater
distance than 20 metres (22 yards). Always
keep the working area and the machine
under good supervision.
Never give the transmitter to anyone who is
not fully conversant with the machine, its
operation and safety directives.
Repeated high speed setting is only possible
after 30 sec of low speed.
Operating
2. Speed switch, High/Low
OPERATION – RADIO REMOTE CONTROL UNIT
L000338A
2
WARNING
WARNING
WARNING
WARNING
CAUTION

Related product manuals