Need help?Do you have a question about the DYNATEK TC88-1 and is the answer not in the manual?
General| Brand | DYNATEK |
|---|---|
| Model | TC88-1 |
| Category | Accessories |
| Language | English |
Details the DYNA TC88-1 as a microcomputer-controlled ignition system for Harley-Davidson TwinCam 88 motorcycles, offering accurate control and customizability.
Guides users through removing the stock ignition module, connecting the DYNA TC88-1, and securing it properly.
Emphasizes using suppression spark plug wires (300-4000 ohms) to prevent radio frequency interference and potential ignition malfunction.
Advises using dual coils with primary resistance under 1 ohm, like stock Harley or Screamin' Eagle, and specific Dyna coils for dual plug heads.
Explains how to select the appropriate advance curve based on engine modifications, riding conditions, and testing for pinging.
Details the available rev limit settings from 5750 to 7500 RPM in 250 RPM steps for engine protection.
Describes how the DYNA TC88-1 controls the check engine light during self-diagnostics and engine start-up.
Explains how the system uses the Manifold Air Pressure sensor to smoothly vary ignition advance for optimal part and full throttle operation.
To Next Page
