Dynaudio AIR 15 - Setup Menu ► Monitor Tasks Setup

AIR Menu structure and parameters
Dynaudio Professional AIR reference manual – 2014-09-28 23
Setup menu ►
Monitor tasks setup
Use the Setup monitor tasks menu to assign tasks to
the monitors in your AIR System.
Each monitor must be given a task indicating its func-
tion and position. The System Controller – Master unit
will only be able to identify and control all monitors in
your AIR system correctly if these tasks have been as-
signed correctly.
Selecting the task for an AIR monitor
►
From the home screen, press the ENTER key.
►
Press the DOWN key until “Setup menu” is dis-
played.
►
Press the ENTER key.
►
Press the DOWN key until “Set monitor tasks” is
displayed.
►
Press the ENTER key.
►
Press the UP and DOWN keys to select a monitor.
Each monitor is identied by its serial number,
which is shown on a label with a barcode on the
back.
►
Press the ENTER key.
►
Press the UP and DOWN keys to select a monitor
task.
►
Press the ENTER key to conrm your selection.
►
Press the EXIT key repeatedly to return to the
home screen.
Displayed task name Full monitor task name
No task No task assigned
L Front Left Front
R Front Right Front
Center Center
(C) Sub (C) Subwoofer
L Sub Left Subwoofer
R Sub Right Subwoofer
L Sur Left Surround
R Sur Right Surround
C Sur Center Surround
LsChain Left Surround / Chain
RsChain Right Surround / Chain
CsChain Center Surround / Chain
L Inner Left Inner
R Inner Right Inner
Fig. 8: Available monitor tasks