Need help?Do you have a question about the Dynaudio BM9S and is the answer not in the manual?
General| System | Active subwoofer |
|---|---|
| Bass principle | Closed |
| Frequency response | 29 Hz to 250 Hz (+/-3 dB) |
| Input impedance • + branch • – branch | 20 kOhm 10 kOhm |
| Sensitivity | 75 mVRMS to 5 VRMS, adjustable |
| Output impedance | 100 Ohm (each branch) |
| Phase adjustment | 0°, 180° |
| SAT Highpass | Flat, 60 Hz, 80 Hz, |
| SUB Lowpass | 50 Hz to 150 Hz |
| Woofer • Cone • Coil | 240 mm/10″, one piece molded MSP (Magnesium Silicate Polymer) cone 100 mm/4″, pure aluminium voice coil |
| Inputs • LFE/Slave • SAT/SUB | XLR right/left full bandwidth, XLR |
| Outputs • Slave • SAT/SUB | XLR right/left, Highpass filtered, XLR |
| XLR Pinout | 1: 0 / 2: + / 3: – |
| Max. input voltage | 10 VRMS |
| Auto ON/OFF • Automatic ON (LED green) • Automatic mute (LED red) | when signal is detected at input when no signal is detected for 15 to 20 min. |
| Amplifier power | 200 W, 4 Ohm |
| Power consumption • Standby • max. | 16 W 325 W |
| Mains | 100-120 V, 50/60 Hz, Fuse T3.15 A 220-240 V, 50/60 Hz, Fuse T1.6 A |
| Mode selector | LFE, Slave (Phase and volume controls are bypassed in slave mode). |
Weight and Dimensions| Dimensions, external (height x width x depth) Cabinet volume Weight | 29, 4 cm x 28, 9 cm x 31, 8 cm (incl. feet and grille) 15, 9 liters 10 kg |
|---|
To Next Page
