Need help?Do you have a question about the Dynaudio 9S and is the answer not in the manual?
General| System | Single driver, active 9, 5 in subwoofer |
|---|---|
| Analog inputs | 1 x XLR LFE, 2 x XLR Stereo |
| Analog outputs | 1 x XLR Slave Out, 2 x XLR SAT Out |
| XLR Pinout | 1 = 0 / 2 = + / 3 = – |
| Input impedance – + branch | 20 kOhm |
| Input impedance – - branch | 10 kOhm |
| Frequency response (± 3 dB) | 22 Hz – 175 Hz |
| Box principle | Sealed |
| Max. input voltage | 10 VRMS |
| Auto ON/OFF | Yes |
| Amplifier power | 300 W |
| AC power input | 100-120 V/200-240 V 50/60 Hz |
| Standby power consumption | < 0.5 W |
| Maximum power consumption | 350 W |
| Output impedance | 100 Ohm (each branch) |
| Max SPL | 106 dB |
| High pass filter | Flat / 60 / 80 Hz |
| Low pass filter | 50 Hz -150 Hz |
| Phase adjustment | 0/180 degrees |
| Woofer | 24 cm MSP |
| Mode selector | LFE, Slave (Phase and volume controls are bypassed in slave mode) |
Weight and Dimensions| Weight | 10.5 kg / 23.1 lb |
|---|---|
| Dimensions (W x H x D) | 266 x 276 x 320 mm / 10.5 x 10.9 x 12.6 in |
| Shipping box dimensions (W x H x D) | 400 x 430 x 400 mm / 15.7 x 16.9 x 15.7 in |
Explains safety symbols (lightning, exclamation mark) and hazard levels (Caution, Warning, Danger).
Identifies and labels all controls and connection terminals on the subwoofer's rear panel.
Detailed explanation of each control: Power, Gain, Phase, High-pass, Low-pass, and input/output types.
Instructions for setting up multiple subwoofers in a Master-Slave configuration for enhanced performance.
Step-by-step guide to connect power and switch on the subwoofer, including LED indicators.
Addresses common problems like no power, no sound, or auto-shutoff, with step-by-step solutions.
To Next Page
