Dynaudio 9S User Manual

3. Power (Mode)
On: subwoofer is permanently on
Auto: subwoofer switches on when an input signal is detected
4. Gain
Subwoofer volume level.
5. Phase
Phase setting: phase can be set to 0° or 180°.
6. Low-pass
Subwoofer low-pass frequency: continuously variable from 50 to 150Hz.
7. SAT/SUB (output)
Output for connection of satellite speakers. This signal is processed according to the high-pass filter setting.
8. High-pass
Applies a high-pass filter to the signal routed to the T/SUB output:
Flat: signal is not processed
60: filter frequency at 60Hz
80: filter frequency at 80Hz
9. SAT/SUB (input)
Input for full bandwidth signal. The signal will be processed according to the high-pass filter setting and routed to
the SAT output.
10. LFE
LFE
LFE/Slave: input for LFE signal
Slave: output to (second) slave subwoofer if present
11. Mode
Subwoofer operation mode LFE or Slave:
LFE: select for normal or master use
Slave: select for slave use
Terminal pinout (sockets 9, 10 and 11)
▪ 1 = 0
▪ 2 = +
▪ 3 = –
Damage due to improper connections!
CAUTION
Improper connections may damage the device.
Set the mains power switch to OFF before connecting the 9S.
Only switch on the subwoofer (mains power switch to ON) after all connections and configuration steps have
Before you start 9

Dynaudio 9S Specifications

General

System	Single driver, active 9, 5 in subwoofer
Analog inputs	1 x XLR LFE, 2 x XLR Stereo
Analog outputs	1 x XLR Slave Out, 2 x XLR SAT Out
XLR Pinout	1 = 0 / 2 = + / 3 = –
Input impedance – + branch	20 kOhm
Input impedance – - branch	10 kOhm
Frequency response (± 3 dB)	22 Hz – 175 Hz
Box principle	Sealed
Max. input voltage	10 VRMS
Auto ON/OFF	Yes
Amplifier power	300 W
AC power input	100-120 V/200-240 V 50/60 Hz
Standby power consumption	< 0.5 W
Maximum power consumption	350 W
Output impedance	100 Ohm (each branch)
Max SPL	106 dB
High pass filter	Flat / 60 / 80 Hz
Low pass filter	50 Hz -150 Hz
Phase adjustment	0/180 degrees
Woofer	24 cm MSP
Mode selector	LFE, Slave (Phase and volume controls are bypassed in slave mode)

Weight and Dimensions

Weight	10.5 kg / 23.1 lb
Dimensions (W x H x D)	266 x 276 x 320 mm / 10.5 x 10.9 x 12.6 in
Shipping box dimensions (W x H x D)	400 x 430 x 400 mm / 15.7 x 16.9 x 15.7 in