Dynaudio 9S User Manual

Warranty
Dynaudio Professional products are warranted to be free from defects in components and factory workmanship
under normal use and service for a period of two (2) years when bought from a reseller within the EU.
Dynaudio Professional products are warranted to be free from defects in components and factory workmanship
under normal use and service for a period of one (1) year when bought from a reseller outside the EU.
When failing to perform as specified during the warranty period we will undertake to repair, or at our option,
replace this product at no charge to its owner, provided the unit is returned undamaged and shipping prepaid, to
an authorized service facility or to the factory.
Dynaudio shall not be responsible for any incidental or consequential damages. Dynaudio’s responsibility is limited
to the product itself. Dynaudio assumes no responsibility for any loss due to cancellation of any events, or rent of
replacement equipment or costs due to third party’s or customer’s loss of profit, or any other indirect cost or
losses however incurred. Dynaudio reserves the right to make changes or improvements in design or
manufacturing without assuming any obligation to change or improve products previously manufactured and / or
sold.
The product warranty is only valid in the country where the product was purchased.
Exceptions
Dynaudio will always follow the law of the respective markets should it dier from the policy stated above or the
exceptions stated below.
This warranty shall be null and void, if the product is subjected to repair work or alteration by a person or facility
other than those authorized by Dynaudio; mechanical damage including shipping accidents; war, civil insurrection,
misuse, abuse, operation with incorrect AC voltage, incorrect connections, wrong accessories, incorrect use of
accessories, operation with faulty associated equipment, exposure to inclement weather conditions and normal
wear and tear.
Units on which the serial number has been removed or defaced, are not eligible for warranty service.
Warranty 23

Dynaudio 9S Specifications

General

System	Single driver, active 9, 5 in subwoofer
Analog inputs	1 x XLR LFE, 2 x XLR Stereo
Analog outputs	1 x XLR Slave Out, 2 x XLR SAT Out
XLR Pinout	1 = 0 / 2 = + / 3 = –
Input impedance – + branch	20 kOhm
Input impedance – - branch	10 kOhm
Frequency response (± 3 dB)	22 Hz – 175 Hz
Box principle	Sealed
Max. input voltage	10 VRMS
Auto ON/OFF	Yes
Amplifier power	300 W
AC power input	100-120 V/200-240 V 50/60 Hz
Standby power consumption	< 0.5 W
Maximum power consumption	350 W
Output impedance	100 Ohm (each branch)
Max SPL	106 dB
High pass filter	Flat / 60 / 80 Hz
Low pass filter	50 Hz -150 Hz
Phase adjustment	0/180 degrees
Woofer	24 cm MSP
Mode selector	LFE, Slave (Phase and volume controls are bypassed in slave mode)

Weight and Dimensions

Weight	10.5 kg / 23.1 lb
Dimensions (W x H x D)	266 x 276 x 320 mm / 10.5 x 10.9 x 12.6 in
Shipping box dimensions (W x H x D)	400 x 430 x 400 mm / 15.7 x 16.9 x 15.7 in