EasyManuals Logo

DynaVox VT-80MK User Manual

DynaVox VT-80MK
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
29
USER INFORMATION
and does not constitute an obligation on the part
of the trademark owner.
The latter assumes no responsibility or liability for
errors or inaccuracies, which may be contained in
this manual. Dynavox is a registered trademark of
Sintron Distribution GmbH, 76473 Iffezheim, Germany.
This document is a product of Sintron Distribution
GmbH, 76473 Iffezheim and may not be copied or
distributed in whole or in part without explicit and
written permission.
Automatic shutdown in the sense of the Ecodesign
Regulation
This device switches itself off automatically after
approx. 30 minutes without an input signal or at
volume 0 and then consumes less than 0.4 watts.
To switch the device on again, the on / off switch
(1) must be pressed twice. This device does not
have a standby or standby state. To deactivate the
automatic switch-off, set the corresponding switch
on the back(26) of the device to the "Autostandy
OFF" position. If the device is not used for a long
time, it is generally recommended to disconnect the
device from the mains.
Minimum quality: highly sensitive audio amplifiers are apt to generate demodulation products in the vicinity
of rf sources.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DynaVox VT-80MK and is the answer not in the manual?

DynaVox VT-80MK Specifications

General IconGeneral
BrandDynaVox
ModelVT-80MK
CategoryAmplifier
LanguageEnglish

Related product manuals