35
18. Signal Input (AUX1)
Stereo RCA socket for external analog sources.
19. Signal Input (AUX2)
Stereo RCA socket for external analog sources.
20. Signal Output (PRE-OUT)
Regulated and amplified signal output, to transfer
to additional power amplifiers or active-subwoofers.
21. Speaker Connection (SPEAKER A und B)
Speaker connectors with screw connection or with
4 mm banana plugs, for up to 4 speakers.
(Under usage of suitable speakers (8 - 16 Ohm), it
is possible to run two speaker pairs at once.)
22. Power Socket (AC 230V/50Hz)
Socket to plug the power cord in scope of delivery.
23. FM Antenna (FM ANT.)
Connection socket for FM Tuner antenna.
24. BT Antenna (BT ANT.)
Connection socket for BT antenna.
25. Fuse Holder (FUSE)
Device fuse. (follow the safety instructions!).
26. Auto-Standby (A-S ON/OFF)
The auto standby function can be switched off here.
If this switch is set to "I" (On), the VT-80MK swit-
ches off automatically after approx. 30 minutes wit-
hout an input signal or at volume 0. To switch off
this function, set the switch to the "0" position
(off).
To Next Page
Loading...
