29
13. Digital input coaxial
Digital stereo input with coaxial connection.
14. Digital input optical
Digital stereo input with optical connection.
15. Phono input
Stereo RCA socket for turntables with MM-System.
16. Signal Input (AUX)
Stereo RCA socket for external analog sources.
17. Signal Output (OUTPUT)
Regulated and amplified signal output, to transfer to
additional power amplifiers or active-subwoofers.
18. Speaker Connection (SPEAKER A und B)
Speaker connectors with screw connection or with 4 mm
banana plugs, for up to 4 speakers.
(Under usage of suitable speakers (8 - 16 Ohm), it is
possible to run two speaker pairs at once.)
19. BT-Antenna (BT ANT.)
Connection socket for BT antenna.
20. Auto-Standby (A-S ON/OFF)
The auto standby function can be switched off here.
If this switch is set to „I“ (On), the VT-90 switches off
automatically after approx. 15 minutes without an input
signal or at volume O. To switch off this function, set the
switch to the „O“ position (off).
21. Power Socket (AC 230V/50Hz)
Socket to plug the power cord in scope of delivery.
22. Fuse Holder (FUSE)
Device fuse. (follow the safety instructions!).
To Next Page
Loading...
