To Next PageTo Next PageWhat to do if Dynon Avionics GPS position is shown in red?
If the GPS position is shown in red, it indicates a conflict. Only one GPS device can be set as POS 1. Resolve this conflict to correct the issue.
Why is my Dynon Avionics GPS not getting a GPS fix?
If your SV-GPS-250/2020 GPS unit doesn't acquire a GPS fix immediately after being powered on for the first time, or after it has been off for several weeks, allow several minutes for it to acquire GPS signals.
What to do if RX COUNTER and GOOD SENTENCES are not incrementing on Dynon Avionics GPS?
If the RX COUNTER and GOOD SENTENCES are not incrementing, it may indicate a wiring issue with your SV-GPS-250/2020. Check the wiring, ensuring that the Gray/Violet and Gray/Orange wires are correctly connected between the unit and the SkyView display.
How to fix incorrect device selected in SERIAL IN DEVICE for Dynon Avionics GPS?
To fix an incorrect device selection, ensure that the SERIAL IN DEVICE setting matches the connected device—either SV-GPS-250 or SV-GPS-2020. Otherwise, no GPS data will be received.
General| Display Type | LCD |
|---|---|
| Resolution | 800 x 480 pixels |
| GPS Update Rate | 5 Hz |
| Database Update Interval | 28 days |
| Input Voltage | 10-30 VDC |
| Power Consumption | 10 W |
| Operating Temperature | -20°C to +55°C |
| Navigation Database | Built-in |
| GPS Receiver | WAAS GPS |
