Dyson AB10 Owner's Manual

3
LOOKING AFTER YOUR HAND DRYER
WARNING
This product is not to be used in sinks where a plug is fitted. Before engaging
the water flow ensure that the plughole is clear of any obstructions and that
water can drain freely.
HOW TO USE
1. Place your hands beneath the centre of the tap and it will start the water flow
automatically for as long as the hands remain in place.
2. Place your hands to either side of the centre tap to activate the hand dryer,
creating sheets of air to scrape water from your hands.
3. Move your hands backwards and forwards slowly through the air, turning them
over so both back and front are exposed to the airflow.
TROUBLESHOOTING GUIDE
Problem Action
The hand dryer fails to start. Check fuse/circuit breaker is working and that
the power and water supply are connected.
Ensure the cleaning cap is removed and that the
sensors are clean and unobstructed.
Turn the machine on and off.
The hand dryer is turning on and off erratically. Ensure sensors are clean.
Check that the sensor cable from the tap is
securely connected.
The hand dryer sometimes cuts out when in use
but resumes operation after a period of time.
Check the air inlet is clean and free of dust.
If the air inlet is dusty simply remove dust.
Ensure that the air inlet is free from obstructions
and has sufficient clearance (see installation
instructions).
The dry time of the hand dryer has increased.
The air flow from the hand dryer is running
hotter than usual.
Inspect the inlet grill for dust and remove.
Inspect filter and change if required.
Ensure that the hose is securely attached to the
base of the tap and no leaks are present.
Air is continuously running from the hand dryer. Ensure sensors are clean and free from any
obstructions
Problem Action
There is no air coming from the hand dryer. Check fuse/circuit breaker is working and that
the power is connected.
Ensure that the air hose is securely attached to
the base of the tap and no leaks are present.
Check that the sensor cable from the tap is
securely connected.
TAP
Problem Action
Water is continuously coming from the tap. Ensure sensors are clean and free from any
obstructions.
There is no water coming from the tap. Ensure that the power and water supplies are
turned on and that the isolation valve is open.
Ensure that the aerator is free from debris,
remove and clean / replace if necessary.
The water coming from the tap is overly hot
or cold.
Contact the Dyson Helpline.
If you have any further questions please contact the Dyson Helpline.
CLEANING
The hand dryer should be cleaned daily.
Follow these 2 simple steps to ensure the unit performs to its best and remains
hygienic. Using the wrong cleaning method or product may invalidate your
guarantee.
1. Fit the cleaning cap, and wipe all surfaces with a soft cloth and
non-abrasive cleaner.
2. Clean the air inlets on the base of the motor bucket REGULARLY.
GENERAL ADVICE
All cleaning chemicals should be used exactly as indicated by the
manufacturer’s instructions (including appropriate dilution).
If a cleaning product is left on the machine for too long, a film will form.
Any chemicals intended for use should first be tested on an inconspicuous area to
confirm suitability.

Dyson AB10 Specifications

General

Brand	Dyson
Model	AB10
Category	Dryer
Language	English