Overhead view showing
soap dispenser
clear zone.
60 mm 60 mm
60 mm
Sink dimensions
(All internal measurements unless otherwise stated)
Fig.1 Width of sink minimum: 350 mm.
Front to back of sink minimum: 300 mm.
Fig.2 Maximum depth of sink for Long Neck Tap (AB10) only: 200 mm
(External measurement of vessel/pedestal sink).
Fig.3 Minimum distance from tap centre to top of sink
(AB11 only) 100 mm. Front edge of sink (all types – pedestal,
recessed, slab) to wall minimum 385 mm.
Fig.4 Do not place the downward facing water sensor of
the tap over a reflective surface, such as the drainage hole.
Tap mounting
The tap stem (measured from the outside diameter) should
be mounted 15-40 mm from the outside edge of the sink.
There should be a minimum of 290 mm between a tap
centre and a side wall. When multiple taps are installed
side-by-side, tap centres should be a minimum of 580 mm
apart. This allows sufficient space for mounting the motor
bucket, as well as sufficient shoulder room for users.
Do not place the downward facing water sensor of the tap
over a reflective surface, such as the drainage hole (Fig.4).
Sink specification guidelines
Using a specially designed test method, Dyson
engineers tested a wide range of sinks to assess their
compatibility with the Dyson Airblade Tap hand dryer.
For recommended sinks, please contact us.
Porcelain or brushed metal sinks are ideal.
Sinks with highly polished surfaces should
be avoided e.g. reflective chrome.
350mm minimum
300mm minimum
385mm minimum
100mm minimum
Fig.1
200mm maximum
Fig.2
Fig.3
Fig.4
350 mm minimum
300 mm minimum
200 mm maximum
100 mm minimum
385 mm minimum
Wall
Pre installation overview
Short
Long
mm minimum
Soap and locating the soap dispenser
For the best user experience, Dyson recommends
the use of gel soaps.
The infrared sensing zone for air activation extends
along each tap branch. In order to prevent accidental
activation, it’s important to consider the user’s
hand route to the soap dispenser.
The dispenser should be located at least 60 mm
outside the width of the tap, so the user reaches
around the side of the branch.
It should also be located at least 60 mm above
the branches, so that the sensors are not activated.
Please note that the user may reach diagonally
across for the soap, so this path must not go
through the sensing zone.
Front on view showing
soap dispenser
clear zone.
60 mm60 mm
60 mm
100 mm minimum
42 43
Visit website for full downloadable pre
installation guides for AB09, AB10 and AB11.
www.dyson.com.au/docs
To Next Page
Loading...
