Soap and locating the soap dispenser
For best user experience, Dyson recommends the use of gel soaps.
The infrared sensing zone for air activation extends along each
tap branch. In order to prevent accidental activation, it’s important
to consider the user’s hand route to the soap dispenser.
The dispenser should be located at least 2
3
/
8
" outside the width
of the tap, so the user reaches around the side of the branch.
It should also be located at least 2
3
/
8
" above the branches,
so that the sensors are not activated.
Please note that the user may reach diagonally across for the
soap, so this path must not go through the sensing zone.
Front on view showing
soap dispenser
clear zone
Over head view showing
soap dispenser
clear zone
2
3
/
8
"2
3
/
8
"
2
3
/
8
"
2
3
/
8
" 2
3
/
8
"
2
3
/
8
"
Tap mounting
Do not place the downward facing water sensor of the tap
over a reflective surface, such as the drainage hole. (Fig.5)
For complete instructions, please refer to the printed
installation guide supplied with the machine.
It’s also available online at www.dyson.com/docs
Fig.5
AB09 AB10 9
1
/
2
"
AB11 12"
For further information please contact Dyson.
1-888-397-6622
www.dyson.com
Dia. 1
3
/
8
"
WWW.RESTROOMDIRECT.COM 704
•
937
•
2673 129 Oakpark Dr., Unit A, Mooresville, NC 28115
To Next Page
Loading...
