PRE-INSTALLATION INFORMATION
Sink dimensions (All internal measurements unless otherwise stated)
Fig.1 Width of sink minimum: 13
7
/
8
", Front to back of sink minimum: 12" Internal
depth of sink minimum (for all taps): 4"
Fig.2 Maximum depth of sink for Long Neck Tap (AB10) only: 7
7
/
8
"
(External measurement of vessel/pedestal sink)
Fig.3 Minimum distance from center of horizontal arm to top of sink
(AB11 only) 4". Front edge of sink (all types – pedestal, recessed, slab)
to wall minimum 4".
Fig.4 Minimum distance between tap center and a side wall 11
1
/
2
".
Multiple taps should have a minimum distance between tap centers of 23".
Tap mounting
The tap stem (measured from the outside diameter) should
be mounted
1
/
2
" - 1
1
/
2
" from the outside edge of the sink. (Fig.2)
There should be a minimum of 11
1
/
2
" between a tap center and
a side wall. When multiple taps are installed side-by-side, tap
centers should be a minimum of 23" apart. This allows sufficient
space for mounting the motor bucket, as well as sufficient
shoulder room for users. (Fig.4)
Sink specification guidelines
Using a specially designed test method, Dyson engineers tested
a wide range of sinks to assess their compatibility with the Dyson
Airblade Tap hand dryer. For recommended sinks, please use
our guide at www.dyson.com/docs
Porcelain or brushed metal sinks are ideal.
Sinks with highly polished surfaces should be avoided
e.g. reflective chrome.
350mm minimum
To Next Page
Need help?
General