Installing AB11
The AB11 Dyson Airblade Tap hand dryer is designed so that the
motor unit is located behind a stud wall within a metal enclosure
which is supplied with the Dyson Airblade Tap hand dryer (Fig.13).
The vertical wall studs must be constructed so as to allow the metal
enclosure to be fitted between them (Fig.14). One of the horizontal
wall studs must be fitted a) so it holds the main weight of the metal
duct and the unit, and b) so it is in the correct position for the
tap stem.
For complete instructions, please refer to the printed
installation guide supplied with the machine.
It’s also available online at www.dyson.com/docs
AB11 metal enclosure assembly
Fig.13
Fig.14
For further information please contact Dyson.
1-888-397-6622
www.dyson.com
WWW.RESTROOMDIRECT.COM 704
•
937
•
2673 129 Oakpark Dr., Unit A, Mooresville, NC 28115
To Next Page
Loading...
