I regretted not reading Gers_v post before making a futile attempt in removing the nut ...just like
Gers_v said there seems to be something broken inside that resulted in F02 being displayed.
Anyway, I went ahead to applied some UHU glue on the nut. The F02 Error is now gone
Thanks for the post. I’m trying to fix a whirring/ loud fan sound on my Dyson Pure Cool Link Tower.
Unfortunately I cleaned out everything, even though it’s was pretty clean in there once I opened it
up. Put it all back together, but it’s still really loud. I think the motor needs replacing, but I can’t find
the part anywhere online.
Thanks for sharing the guide. I'd like to pay it forward..
Unfortunately today i tried to remove the fan itself by unscrewing the nut. And it got damaged. :-( It
seems the bolt inside is glued to the fan motor but unscrewing the nut sort of breaks what's inside.
Please do not make the same mistake I did. Best regards.
This is a really comprehensive clean out. Thank you for sharing your process :-)
To Previous Page
Loading...
