Finding blockages
9
• Turn power off and unplug
before checking for blockages.
• If any part of the machine
becomes blocked, it may
automatically shut off. Unplug
machine and clear blockage
before restarting.
Please note: Clearing blockages
is not covered by your
machine’s guarantee. (Keep
your proof of purchase safe.)
Beware of sharp objects when
clearing blockages.
Refit all parts of the machine
securely before using it.
On models with brush control, a
ratchet noise warns that the
brushbar is obstructed. Ensure
machine is disconnected from
the power supply before
clearing the obstruction.
A Check tools, wand and hose are
clear of blockages.
B To remove the hose, press hose
release button at front of machine
and slide hose out.
U bend inspection
C Tilt machine forward, slide out
U bend and check inside
for blockages.
Airway inspection valve
D Squeeze release catches and
check inside for blockages.
Brushbar obstructions
Remove wand and cyclone assembly
and turn machine upside down.
Undo fasteners using a coin and
remove soleplate.
Remove fluff and hair from brushbar.
Rest the 3 tabs on inside of yellow
bumper and replace soleplate,
tightening the fasteners.
Ensure soleplate is in correct position
before use.
Important information
B
A
D
C
To Next Page
Loading...
Need help?
General
