51 Connect the Main power loom to the
Main PCB assembly.
52 Retain the Main power loom with
Ferrite core into the details provided.
50 Feed the power loom through the
hole in the top right hand side of the
main body.
34
54 Slide the bottom of the Filter release
catch into the details in the Main
body.
55 Secure the Filter release catch with
the two T-8 screws.
Repeat on the opposite side.
53 Ensure the power loom is positioned as shown to avoid trapping.
35
After fitting the screws, continuing fitting the following components as previously shown:
Air AMP Service assembly (Page 21 - 24, steps 25 - 30)
To Next Page
Loading...
