02 Remove the Evaporator assembly.
Shut the Evaporator door.
01 Press the release catches on either
side of the filter housings. Remove the
filter Housing and Filter assemblies
from the product.
Note: if the product is a Cryptomic
variant, it won’t be necessary to
remove the Cryptomic filter.
Repair notes
AMP Service Assembly - removal
10
03 Remove the eight T-15 screws under the Amp service assembly to the front and rear of the
product.
04 Carefully lift off the Amp service
assembly.
Important: the Amp assembly will be
connected by four looms.
05 Carefully disconnect the four looms.
11
To Next Page
Loading...
