Dyson PH02 - Motor and Bucket Service Assembly - Removal

56 Disconnect the Motor loom from the
Main PCB assembly.
57 Remove the Motor to amp seal.
58 Push the Grommet, loom and
connector through the hole in the
Main body. Open the Evaporator
door.
Repair notes
Motor and Bucket Service Assembly - removal
Before continuing the following components will need to be removed as previously shown:
Air amp service assembly (Pages 10 - 11, steps 01 - 05)
36
59 Feed the Grommet and connector
through the hole.
60 Ensure the Evaporator door is open.
37