Dyson PH02 - Connection Shuttle Service Assembly - Fitting

73 Remove the six T-8 screws holding the tray to the Main body.
74 Disconnect the Shuttle Loom from the
Power controller PCB and release the
loom from the retainers in the side of
the Main body.
75 Remove the Connection Shuttle
Service assembly from the Main
body.
46
76 Slide the new Connection Shuttle
Service assembly into place ensuring
all the looms are free from trapping
and no seals have folded over.
77 Fit the six T-8 screws.
Repair notes
Connection Shuttle Service Assembly - fitting
47