99 Press the holder down and fit the two T-8 screws.
IMPORTANT: whilst tightening the screws check that the gasket does not become mishapen or the
DC Jack misplaced.
100 Retain the Internal Power Harness into the details provided in the Lower body.
56
101 Place the Base plate onto the Lower
body.
Fit the two countersunk T-8 screws.
102 Locate the detail in the centre of the Base Skirt onto the centre of the Lower body Service
assembly.
Push down on the centre to secure the Base skirt in place.
57
To Next Page
Loading...
