39
Diffused and focused modes
Sleep timer
Oscillation and airflow speed control
Tilt function
To set the sleep timer, press and hold the timer button
to select the desired time. When time reaches zero, the
appliance will go into standby mode. To cancel, increase
the time until two dashes appear.
When using the sleep timer, the LED display will turn off
after 10 seconds of inactivity.
Airflow speed control
To change the airflow speed
press the airflow control button.
The digital display will show
the new fan speed. If in heater
mode after 2.5 seconds it will
change back to displaying the
target temperature.
Oscillation control
To start the appliance
oscillating, press the oscillation
control button. To stop the
appliance oscillating, press
it again. The appliance will
not oscillate when the control
buttons are pressed.
Carefully hold the base and the main body. Tilt the amplifier
forward or backward for the required airflow angle.
Focused mode
Press the narrow angle button to
change from a wider projection
of airflow to a personal directed
airflow.
Diffused mode
Press the wide angle button
to change from a personal
directed airflow to wider
projection of air flow.
Heating and cooling modes
work in this mode.
Heating and cooling modes
work in this mode.
To Next Page
Loading...
