38
Heating and cooling modesRemote control
Remote control docks magnetically.
Attach the remote control to the top of the
machine with the buttons facing down.
To operate, point the
remote control toward
the front of the base.
Each time the heating mode is selected, it conducts a
short calibration cycle. Airflow will be automatically
controlled during this cycle. Once the calibration cycle is
complete, it will revert to the selected airflow speed.
Press and hold the power button to
run through the target temperatures.
Press the blue cooling mode button to enter cooling mode. The
power button light will change from red to blue to indicate that you
have entered cooling mode. To adjust the airflow speed use the
airflow control button.
Press the red thermostat control button until the digital display shows
the target room temperature. The power button light will change from
blue to red to indicate that you have entered heating mode. The red
circle will disappear when the target room temperature is reached.
Once the target room temperature has been reached, the appliance
will stop heating the air. If the room temperature falls below the target
room temperature, the appliance will start to heat again.
Standby
ON/OFF
Airflow speed
control
Sleep timer
Focused
mode
Oscillation
ON/OFF
Diffused mode
Thermostat
control
Cooling
mode
On first use, the appliance will default to a temperature
3°C higher than the detected room temperature.
Thereafter, the appliance will remember the last target
temperature set.
Select the desired room temperature. Pressing the
large red button increases the target temperature
by 1°C; the smaller red button decreases it by 1°C.
The appliance will not operate in heater mode
unless the target temperature is above the room
temperature.
Power
To Next Page
Loading...
