Clearing blockages from your
Hair screw tool
Remove the cover and brush bar
Pull your brush bar firmly to remove it from the main body.
Check and remove any obstructions from all three parts of your Hair screw
tool.
Your Hair screw tool isn't washable. Wipe over with a damp lint-free cloth.
Don’t put any part of your machine in a dishwasher or use detergents,
polishes or air fresheners.
Remove the Hair screw tool from the wand or machine.
Push the base plate open. Press the red lever down to release the cleaner head
cover.
Pull the cleaner head cover off the main body of the tool.
Look for obstructions
Re–assemble Hair screw tool
Your Hair screw tool doesn't have a washable brush bar. To maintain optimum
performance, check your brush bar regularly and clear any obstructions.
Make sure your machine is disconnected from the charger and take care not to
touch the trigger.
The curved locking
lever located on the
back of the tool.
Remove any hair or fibres
that have been wrapped
around the brush bar.
To Next Page
Loading...
