DYU FF500 - Installing the Front Wheel

INSTALLING THE FRONT WHEEL
Installing the Front Wheel
I. Basic mechanical principle with the hub and anchor nuts
Turn the anchor nuts clockwise to increase clamping, and anti-clockwise to decrease.
II. How to install
1. Manually turn the anchor nuts anti-clockwise to loosen for space, and insert the front
wheel all the way into the dropouts of the front fork.
2. Manually turn the anchor nuts clockwise to fasten up. Ensure that the front wheel is located at
the very center of the front fork, and that the disc brake rotor is parallel to the disc brake caliper
towards the end of the front fork with space in between. Keep some space on both sides, and
tighten into place with a spanner as indicated below.
Correct Wrong