E-Glide D 150 - Assembly Instructions; Steerer Tube and Handlebar Installation; Securing Assembly and Power Test; Charging Instructions

4 5
ASSEMBLY INSTRUCTIONS CHARGING INSTRUCTIONS
1 Secure the steerer tube and flick the
kickstand down
3 Use the hex wrench to lock the
screws on both sides
2 Install the handlebar
4 Turn on the scooter using the
on/of buton to test for power.
1 open the rubber plug
2 Inser the charging plug, when light on charger
turns from red to green the scooter is fully charged.
3 Tighten the rubber plug afer charging finished.