8. Installation guide
8.1 Take out the E-bike and check the parts list
① Complete E-bike packaging is as shown in the figure below, and check whether the parts are damaged.
② Check whether the parts are complete. The seat post saddle and handlebars are tied to the E-bike, and the
front wheel quick release is tied to the front fork legs. (Use scissors to cut the cable tie for assembling use)
In addition, there are pedals, charger, charger cable and tools in the cardboard box.
8.2 The front wheel
①Tear off the front fork packaging and install the front wheel on the front fork.
②Pay attention to the orientation of the front wheel: the front wheel disc is on the same side as the front fork
disc brake seat, and the axles on both sides are installed in place.
③Install the quick release, loosen the screw, the quick release handle is in the same direction as the disc
brake, pass the other side, install the spring and nut.
④Tighten the nut and turn the quick release handle upward Press tightly, pay attention to the handle pressing
force not too loose, to ensure that the front wheel is locked.
⑤After the front wheel is assembled. turn the front wheel to check whether the front wheel rotates smoothly.
To Next Page
Loading...