E-Seek 200 - Factory Setup; Factory Default; Scanner Settings; Current Settings

- 5 -
Factory Setup
Description: To restore all factory settings, this command will overwrite all existing
setting with the factory default settings.
Scanner Response: ACK if the factory restore is completed successfully / NAK
Description
Field
Values allowed
Factory Default
Default
FACDEF=1
Table 1.1
Scanner Settings
Description: To request current setting parameters (SETPAR), scanner model number
(FINGER) or request a respond to a ping command (TXPING).
Scanner Response: (SETPAR) ACK followed by a complete list of settings, (each
field is sent separately with its start and stop character) and
followed by \r\n after the last field/ NAK
(FINGER) ACK followed by a model name and \r\n / NAK
(TXPING) ACK / NAK
Description
Field
Values allowed
Current Settings
SETPAR:
Send Scanner Model
FINGER:
Sending a Ping
TXPING:
Table 1.2
Scanner Revisions
Description: To request an Application 1, 2 or Hardware revision number.
Scanner Response: (APP1RV) ACK “N.NN.NN\r\n” / NAK
(APP1RV) ACK “N.NN.NN\r\n” / NAK
(HARDRV) ACK “N.NN.NN\r\n” / NAK
(SERIAL) ACK “NNNNNNNNNN\r\n” / NAK
N is an ASCII „0‟ – „9‟, All responses have a fixed length
Description
Field
Values allowed
Send Revision Number
Application 1
APP1RV:
Application 2
APP2RV:
Hardware
HARDRV:
Table 1.3