To Next PageTo Next Page
Need help?Do you have a question about the E-Seek 200 and is the answer not in the manual?
Defines serial command structure including start, commands, and end characters.
Specifies SOH (ASCII 01) as the starting point for serial programming.
Explains command data is enclosed in '<>' characters.
Specifies EOT (ASCII 04) as the required end character.
Details scanner responses (ACK/NAK) to commands.
Command to restore all factory settings to default values.
Request current setting parameters from the scanner.
Command to request the scanner model number.
Command to request a ping response from the scanner.
Command to request Application or Hardware revision numbers.
Command to read or set the serial number, with length constraints.
Option to enable or disable adding serial number to the stream.
Command to retrieve the web address stored in the scanner.
Configures RS232 data bits, parity, stop bits, flow control, baud rate, and character delay.
Command to read the registration key.
Option to enable or disable adding registration key to stream.
Command to write the registration key.
Configures the scanner's speaker volume.
Configures beeps that occur during scanner power-up.
Configures beeps after scanner setup changes.
Command to set prefix parameters.
Option to enable or disable adding AIM ID to prefix.
Command to set suffix parameters.
Option to enable or disable adding CR/LF to suffix.
Configures Code39 barcode parameters.
Configures handling of Code 39 start/stop characters.
Configures Code128 barcode parameters.
Configures PDF417 barcode parameters.
Enables or disables power saving mode to minimize consumption.
Details power consumption levels and timings in power saving mode.
Configures parameters for magnetic stripe tracks 1, 2, and 3.
Configures track data with LRC (Check Character).
Configures raw data output, encoded into ASCII characters.
Configures the message displayed for no-read conditions on tracks or barcodes.
Specifies the application code upgrade type (Zmodem, VISA, Generic).
Specifies the second application code upgrade type.
Details pin assignments for RJ-45 serial ports on models 200/250.
Details pin assignments for RJ45 and Kiosk connectors on model 260.
General| Interfaces Supported | USB, RS232, Keyboard Wedge |
|---|---|
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Storage Temperature | -20°C to 60°C |
| Humidity | 5% to 95% (non-condensing) |
| Drop Resistance | 1.5m |
| Operating Voltage | 5V DC |
| Supported Barcode Types | UPC-A, UPC-E, EAN-13, EAN-8, Code 39, Code 93, Code 128, Interleaved 2 of 5, Codabar |
