E-Tech IM400 - Antenna Installation and Compliance

FILE: IM400 Service manual.doc 2004.11.23
E-TECH Co., Ltd 17/19
3) to select
4)
or to select ON /OFF.
5)
to select
27. Status call Send
1).
to enter Menu Mode.
2)
or to until
3) to select
4)
or to select ON /OFF.
5)
to select
5. Antenna Installation
5-1 Antenna Installation and Compliance with Radio Frequency(RF) Energy Safety
Standards
[IMPORTANT NOTE]
To assure optimum performance and compliance with RF Energy Safety standards, this
antenna installation guidelines and Instructions are limited to metal-body vehicles with
appropriate ground planes and take into account the potential exposure of backseat
passengers and bystanders outside the vehicle.
[NOTE]
For mobile radios with rated power of 7 watts or less, the only installation restrictions are
to use only E-tech approved antennas and install the antenna externally on metal body
vehicles. For mobile radios with rated power greater than 7 watts, always adhere to all
the guidelines and restrictions in 5.2 below.