© 2020 E2 Scientific Corp. Version 5.20.2020. All rights reserved.
Maximum Endurance. This exercise measures the highest pressure achieved when applying pressure to
the bulb. To perform the exercise:
1. Open the Maximum Endurance module.
2. Adjust the target range by sliding the blue dots on the “Min-Max Bar” to set the desired
minimum and maximum pressure range.
o You will need to set the target range for this module, even if you have already set it for
the Repetitive Strength and/or Isometric Endurance modules.
o If you swipe to another module or close and reopen the application, the pressure range
on the Maximum Endurance module will not change.
o The application requires there to be at least a 5 kPa difference between the minimum
and maximum setting.
3. Place the bulb on your tongue and squeeze it against the roof of your mouth until the meter’s
needle moves into the target range; maintain that pressure for as long as you can.
o The numerical display on the bottom right records the maximum length of time the
pressure was maintained in or above the minimum of the set range.
o If the pressure drops below the minimum target range, the stopwatch will stop.
o Changing the target range will not reset the stopwatch.
o The reset button resets the stopwatch to zero.
o The Data Report will store the maximum length of time even if a user presses RESET.
To Next Page
Loading...