© 2020 E2 Scientific Corp. Version 5.20.2020. All rights reserved.
User Guide
Bulb Placement: Once the bub is securely attached to the device, place the bulb in the mouth so that it
rests on the tongue just behind the front teeth. Your SLP can advise alternative placements of the bulb in
your mouth.
The circular unit at the top of the Tongueometer device is designed to be a lip guard to prevent the bulb from
slipping into the back of the mouth. Users can adjust the length of the tubing for optimal placement. Adjust
the length of the tubing so that the mouth guard is flush with your lips. Never bite down on the bulb or
tubing as this may impose a choking hazard to the user or result in damage, causing the device to
work inaccurately.
Bulb Care and Replacement: Gently clean the bulb with a damp cloth following each use and store in a
clean, dry area (See Caring for the Tongueometer section for more details). Bulbs are designed for use by a
single individual. If a bulb becomes damaged, discontinue use immediately and replace. It is recommended
that you replace the bulb every 8 weeks. Never submerge a bulb in liquid. To replace the bulb, gently pull on
the tubing connected to the top of the device until it detaches. Dispose of the used bulb in the trash. Then,
rethread a new bulb and tubing (see Setup above).
The Tongueometer application offers four modules:
1. Repetitive Strength: to exercise tongue strength
2. Isometric Endurance: to exercise tongue endurance
3. Maximum Strength: to assess maximum tongue strength
4. Maximum Endurance: to assess maximum tongue endurance
To access the modules, open the Tongueometer app from your phone or tablet. You may switch between
modules at any time by swiping left or right on the screen. The instructions for each module are on the
following pages.
To Next Page
Loading...