Warning
Maintain a flying altitude above one meter
Introduction of the corresponding socket of receiver
Gyro calibration method
1. When flying yaw, first land and calibrate the gyroscope.
2. When calibrating the gyroscope, the aircraft must be
placed on a level ground.
3. The indicator light will flash quickly during the calibration process,
the indicator light stops flashing to take off.
Trimming Notes
Remove the propeller with a hex wrench,
Be careful not to be too tight when installing
the new propeller
When removing and replacing the tail rotor, please
pay attention to the direction, align the motor shaft
and press it slowly to ensure smooth rotation.
Commonly used parts replacement instructions
First pull out the screw, and then pull out the big gear directly downward.
Pay attention to the direction when installing the new gear.
The plane of the shaft should be aligned with the plane of the inner hole
of the gear.
Unplug the plug, then twist the motor
left and right to pull out
LED
LED
Optical flow localization
The tail motor
Main motor
Before and after the steering gear
Aileron steering gear right
Aileron steering gear left
To Next Page
Loading...
Need help?
General
